The variables which determine the state are known as properties.
In Thermal Engineering, state means the exact condition of a substance.
The above properties are also known as basic properties as they may be found by direct observation or simple measurements.
You will find details about these properties as below,
It is the force applied to a unit area.
In an international system (SI) of units, the unit for pressure is the force of one Newton (N) acting on a square meter area which is known as Pascal (Pa) so,
1 Pa = 1 N/meter²
01 Kilo Pascal = 1000 Pa = 1 KPa
1 Mega Pascal = 10, 00,000 Pa = 1 MPa
Another unit for pressure is a bar and atmosphere pressure (atm.)
Gauges are used to measure the pressure of the fluid.
Pressure gauges which used to measure the pressure which is greater than the atmosphere whereas vacuum gauges are used to measure pressure less than atmospheric pressure.
The absolute pressure in the pressure gauge is equal to the observed gauge pressure plus the atmospheric pressure whereas the absolute pressure in the vacuum gauge is equal to atmospheric pressure minus the vacuum.
It is the space that the given substance occupies and it is measured in cubic meters. The most known unit of volume is Liter.
The specific volume of a substance is its volume per unit mass and is generally expressed in meter³/ kg of air at zero degrees centigrade and under a pressure of 760 mm of mercury has a volume of 0.7734 cubic meters.
Therefore, the specific volume of air under this condition is 0.7734-meter³/kg.
The density of a substance is its mass per unit volume is generally expressed in kilogram per cubic meter.
So, under the same conditions of pressure and temperature, if the specific volume of air is 0.7734-meter³/kg then its density is 1.293 kg/mtr³.
It is the measurement of the hotness or degree of the coldness of a given substance.
Ordinarily, temperatures are measured by thermometers; high temperatures are measured by pyrometers.
Also, Small and precise changes in temperature can be measured by resistant thermometers and thermocouples.
In a centigrade thermometer, the freezing point of water is marked as zero and the boiling point as 100 at the atmospheric pressure, these points are called fixed points of a thermometer.
Absolute zero is the temperature at which the internal energy of a substance becomes zero.
The measurement of temperature taken above the absolute zero is known as absolute temperature and expressed in degrees of Kelvin scale or K.
The exact relationship between the Kelvin scale and Celsius scale is,
Temperature K = Temperature degree centigrade + 273.15
I hope the above important information will help you to understand some fundamental properties.
Besides this information, you are suggested to read something more from below engineering books
So, Here you find the Best Engineering Resources for further details
To get the more details about the topic, I further recommended reading
If you like the post, share it with your friends and also on social sites.
Energy conservation may be the best solution to fight the energy problems we are facing today. It will also help…
In engineering, geothermal energy definition is “The heat energy generated and stored in the Earth”. The prefix “Geo” is a Greek word, meaning…
Tidal power or tidal energy is an alternative energy source of hydropower from which you can generate electricity. As tidal energy doesn’t produce any…
Hydroelectric Energy is almost all clean energy sources compared to all other renewable energy sources. Where Nuclear Power generates radioactive waste or wind energy generates…
There are some alternative energy sources available to cope with the increased demand for electricity. These alternative energy resources are…
Green Energy means not the color of energy. Green energy is that source of renewable energy which you can use again and…