A fault may occur in an electric motor due to various reasons.In an Engineering plant, Electric Motors are mostly used to drive the Air Compressor. Electric Motors are mainly two types one is "AlterNet Current" (AC) and the other is "Direct Current" (DC) Motors. The fault…
Many faults may arise due to the un-proper functioning of a solenoid valve. Hence To avoid this fault, the solenoid valve used in the control system must work properly. A solenoid valve is the most sensitive part used for loading/unloading Air compressors.…
A solenoid valve is an integral part of Electro-Pneumatic Control engineering.This valve will control the supply of air to the inlet or suction valve in a load/unload operation of a reciprocating air compressor.Different types of solenoid valves are available on the market. Hence…
An electric motor installed with all the pre-commissioning checks sometimes gives trouble.Sometimes an accident happens to your electric motor and it needs to give attention to before using it again. This is a common engineering practice.If any water or any moisture is observed in…
Electric Motor is the common option to run the air compressor in an engineering plant.This is the cheap alternative available compared with other options such as diesel generators etc.The operating cost of an air compressor can be reduced by using an electric motor as…
Electric Motor is the best option to run the Air Compressor in any engineering unit.Air compressor is the utility that consumes maximum electric power in any plant.Air compressor can be driven by the DG Set also, but it is a very expensive option compared…
Different types of starters are used to start the different types of electric motors.As you know, electric motors are used to drive air compressors.These electric motors are of different types as per the requirement of the customer.As different electric motors are used, different…
Overload Relay is used to Protect Electric Motor from failure due to a high current drawn by the motor.An electric motor has 33% of its cost in total Air Compressor unit, so it is our duty to protect Electric Motor from any…
Different types of starters are used to start the different types of electric motors in engineering plants.In Air compressor engineering, the compressor is driven by an electric motor, and these motors are started by starters according to the requirement.These starters may…
Stator-Rotor Starter is used to start the Wound or Slip-ring Motor.Actually, Stator-Rotor Starter is a very old technology to start the electric motor.Still, some engineering units are using this old technology, if you are from them, you will get help from this post.If…